Repair Kit for MSPA Inflatable Spas
Available in 2 colors: Black or Transparent
Glue included
This kit contains:
- 2 pieces of connectors 15cm X 10cm
- 1 tube of glue
Perfectly suited for your inflatable spa's structure.
Instructions for using the inflatable spa repair kit
1. Thoroughly clean the area to be repaired. Ideally wash with soapy water, rinse, and dry completely
2. Fully deflate the inflatable structure
3. If the damage is relatively small (like a pinhole), apply 4 to 5 drops directly on the hole
4. Cut a small piece to entirely cover the hole. The piece's edge should be located 2 cm from the hole
5. Identify the rough side of the piece to be pressed against the structure
6. Press the piece firmly against the structure on a flat surface for 4 to 5 minutes, the glue should spread perfectly. Excess glue may come out of the piece. Flatten the excess glue against the edges carefully.
7. Allow 24 hours to dry before reinflating the inflatable structure.
For a larger repair, like a tear, apply more generously over the entire surface of the piece that will be glued to the structure.
(It is important not to use a strip that is too long. The size of the piece to be glued depends on the size of your hole/tear)
It is crucial to carry out the repair with the spa deflated and wait 24 to 48 hours before reinflating the structure.