
Suction Kit - Single massage pump 6 - 8 jets
Includes all the necessary parts for the first part of your massage circuit.
Simply and easily build your massage spa with our ready-to-install Boospa concrete spa kits.
The single massage suction kit 6 - 8 jets allows the supply of 6 to 8 massage jets for a concrete spa.
The parts are made of high-quality ABS designed to seal perfectly in concrete.
It includes all the piping parts leading to the pump up to the suction drain as well as a 3 HP single electronically controlled pump.
You can equip yourself with a pneumatic control if you do not use an electronic management system to control the massage pump.
Composition of the suction kit:
Some guidelines to follow:
- If you opt for a pneumatic control kit, the pneumatic hose cannot exceed 5 meters (from the button to the NCC box)
- The suction drain is to be glued and then sealed in the structure.
- To supply more than 4 jets, opt for a 6 - 8 jets suction kit
- The suction kits for massage circuits must be coupled with a hydro-massage jets kit for concrete spas.
- Part number 1: Pump HSP2200 - 3HP
- The HSP2200 pump supplies 6 to 8 massage jets.
- Supplied with 50mm pipe union reducer fitting
- Can be controlled by pneumatic button with a pneumatic control kit (Sold separately)
- Single Phase Power Supply 220V - Pre-wired AMP
- Part number 2: 50mm ball valve
- Allows isolating the circuit to work on the pump without having to drain the circuit
- Quantity: 2
- Part number 3: 50mm straight union fitting
- Connects the wall penetration to the 50mm piping
- Quantity: 2
- Part number 4: Wall penetration fitting
- This piece allows penetrating the structure. It may not be long enough if you use formwork blocks. In this case, you will need to seal the wall penetration + 50mm union fitting + excess piping
- Length: 15cm
- Quantity: 2
- Part number 5: Suction drain
- Allows water suction from the pool to supply the massage pump. For 6 to 8 jets, you will need to double the suction. In the provided kit, the suction drains screw into the nozzles where the central part needs to be removed (Recognizable by a pierced ball in its center)
- Quantity: 2
- Parts numbers 6 and 7: Elbows and tees
- Pieces necessary for doubling the suction
- Quantity: 2 + 1
- Piping: 50mm Pipe + Blue PVC Pressure Glue
- Connects all the parts together.
- Quantity: 5 meters + 1 pot of 250mL blue glue
This is a basic suction kit, it is possible to adapt the parts on request so that the kit can meet specific needs.