MAELSTROM Massage Pump - MS-1 Single-Speed - 3HP
The MS-1 3HP pump provides a longer lifespan capacitor, a sealed bearing, and high-quality Universeal seals.
DIMENSIONS:
- Length: 382mm
- Width: 202mm
- Height: 219mm
FEATURES:
- Single-speed
- Water inlet and outlet of 60mm (2")
- IEC 80 frame motor
- Power: 2.2kW (3HP)
- Power supply: 220-240V 50Hz
- Current: 10.3 A
- Maximum flow rate: 700L/minute
- Rotation speed: 2900 rpm
- High-temperature specified capacitor (85°C) for a longer lifespan
- IPX5 casing Sealed bearing
- Seals: High-quality Universeal by Gecko
- CE compliant
SUPPLIED WITH:
- 2 white 60mm (2") nut-fittings with sliding connector and O-rings
- 3 drain plugs with butterfly nut
- 2.4m cable with AMP plug
- Standard 12 o'clock volute position
- 4 anti-vibration rubber mounts
Technical Diagrams
Pipe Connection
Supplied with fittings for 2" pipes (60 mm interior)
You can also reuse your old pipe fittings if they are still functional.
If your piping differs, check our range of Pump Unions and Fittings to find the fitting that matches your piping
The pump body is adjustable to fit your piping. You can then have a discharge on the left or right depending on your installation. To do this, simply unscrew the 4 motor screws to turn your pump body in the desired direction. Then replace the screws in place.
Electrical Connection
The pump comes with an AMP plug connection cable. You can keep your old cable to connect this new pump. If your plug is no longer usable, you can opt for new plugs in our Spa Cables and Plugs section
Here are the most commonly used Plugs in the Spa world:
 |  |
| AMP Plug | J&J Plug
( PIN position varies depending on the device) |
