Spare parts (page 7)
3050 products
Front Diameter: 57mm
Socket Connection Diameter: 26mm
Water Inlet External Diameter: 16mm
The most powerful model we offer
Power: 5 HP (3.7 kW) – 15 A
Maximum flow rate: 1120 L/min
Supplied with 2.5'' (74 mm) outlet fittings + connection cable with AMP connector
Mainly used in Canadian Spas brand hot tubs.
Reduction: Male 1.5" (48mm) to Male 1" (33mm)
Turbine Diameter: 107mm
Compatible with LP200 and WP200 pumps.
Compatible with LX LP250 and WP250 pumps
Front Diameter: 36mm
Embedded Hole Diameter: 17-20mm
External Diameter of Ribbed Air Inlet: 3/8” (11mm)
Socket included
Visible face diameter: 43mm
Outer thread diameter: 26mm
Suitable for 1/2 inch pipes (outer diameter)
Hydroair Reference: 10-2200
Front diameter: 56mm
Length: 82mm
Thread diameter: 28mm
Outer diameter of the water inlet: 16mm
Socket not included
Front Diameter: 85mm
Length: 95mm
Thread Diameter: 41mm
Water Inlet Outer Diameter: 16mm
Socket not included
Mechanical seal for Waterway pumps
Includes: mechanical part (spring) + ceramic part (stator) + seal
Reduction: Male 1/2" (21mm) to Male 3/4" (20mm fits into the 3/4" hose)
Reference Wateway 419-1920
System that allows reducing pipes from 1" to 20mm.
Stainless steel front - Screw-in jet
Front diameter: 38mm
Included: 1 tightening ring for 2" heater + its female part towards 1.5" pipe
Thread diameter: 78 mm
Female outlet diameter: 48 mm
O-ring included
Attention, the 2 screws to fix the 2 parts of the ring are not included
Lotus Shape
Plug Diameter: 99mm
Pipe Diameter: 2" (60mm)
Gasket not included
Opening and closing of the flow by internal mechanical nozzle
Connection type: Female
Pipe diameter: 1" (33mm)
Reference WATERWAY: 600-3047
Diameter of cap: 93mm
Pipe diameter: 2" (60mm)
2" F/F Manifold - 6 x 3/4" M Barb Outlets
Waterway Reference 672-7120
Made of high-quality ABS
Front diameter: 43mm
Embedded hole diameter: 30-34mm
Grooved air inlet for 3/8” pipe
Gasket and clamping ring included
Temperature sensor for Sundance Spa® and Jacuzzi®
Curl finger connection
Reference 6600-166
Turbine (impeller) for WP300 LX WHIRLPOOL massage pump
Turbine diameter: 118mm
Front diameter: 85mm
Length: 95mm
Thread diameter: 41mm
Outer diameter water inlet: 16mm
Socket not included
Caldera® References - WATKINS: 73995
LED connection box for series connection.
The box is connected to the electronic board and a LED connector.
Front diameter: 69mm
BALBOA Reference: 50-3420WHT
Compatible with Wall Fitting 10-4320
Reduction: Male 2" (60mm) to Male 3/4" (27mm) fits inside a 3/4" hose.
Used to plug a pipe or manifold with a diameter of 0.5 inches (21 mm)
Plug outer diameter: 21 mm
Plug inner diameter: 14 mm
Power: 2.0 HP – 1500 watts
Maximum flow rate: 640 liters/min
Includes 2 fittings for 2'' (60 mm) piping + connection cable with AMP connector
Direct replacement for the massage pump WP200II - LX
Reference LVJ: L-4121T
Length: 78mm
Front diameter: 56mm
Thread diameter: 28mm
Water inlet outer diameter: 16mm
Jet body length: 67mm
Socket not included
Sold with ring + gasket
Embedded hole diameter: 55mm-60mm
Wellis Reference: AJ00170SET
Stainless Steel + Black ABS Front
Directional Jet
The most common pump used in spas sold in France and Europe.
Motor: 56 frame
Power: 2 HP – 1500 W
Without outlet fittings and without connection cable or AMP connector
Gecko Reference: 52272000
Gaskets included
Complete Spa Light 8.3 cm Diameter
Plug Cable Amp + 12V bulb included
Connection: AC12V - 2 wires
Front Diameter: 83mm
Gecko Reference: 05340014-804
Delivers a high flow rate for outstanding energy efficiency
Power: 2 HP
Maximum flow rate: 730 liters/min
Fittings (2" / 60 mm) and cable not included
Reduction: Male 1/2" (21mm) to Female 20mm
Allows the conversion from imperial (inch) to metric (mm) system.
Glue parts
Male air inlet in 1"
Sensor length: 25 mm
Christophe B.
Je recommande vivement
Alexandre R.
Jamais reçu
Alexandre R.
Jamais reçu
Francois S.
Dommage que les raccords ne soient pas en 50mm
Eric B.
produit conforme à mon souhait
Guy-Claude G.
bien
Eric B.
pas encore installé mais fidèle à mon ancien
Bruno M.
La pompe était très bien emballé avec des protections de qualité. Elle vient juste d etre posée, nous verrons la durée de vie🙏
Laurent B.
RAS.
KARIM M.
Pas le bon model , trop long de plus de 2 cm c inadmissible. Merci